kylemanna
5/28/2013 - 7:21 AM
SMART data from the dying OCZ Agility 2
SMART data from the dying OCZ Agility 2
smartctl 5.43 2012-06-30 r3573 [x86_64-linux-3.9.4-030904-generic] (local build)
Copyright (C) 2002-12 by Bruce Allen, http://smartmontools.sourceforge.net
=== START OF INFORMATION SECTION ===
Model Family: SandForce Driven SSDs
Device Model: OCZ-AGILITY2
Serial Number: xxxxxxxxx
LU WWN Device Id: x xxx xxxxxxx
Firmware Version: 1.37
User Capacity: 120,034,123,776 bytes [120 GB]
Sector Size: 512 bytes logical/physical
Device is: In smartctl database [for details use: -P show]
ATA Version is: 8
ATA Standard is: ATA-8-ACS revision 6
Local Time is: Tue May 28 00:19:04 2013 PDT
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x02) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Disabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 0) seconds.
Offline data collection
capabilities: (0x7f) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Abort Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 5) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.
SCT capabilities: (0x003d) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 116 100 050 Pre-fail Always - 0/135697424
5 Retired_Block_Count 0x0033 100 100 003 Pre-fail Always - 0
9 Power_On_Hours_and_Msec 0x0032 100 100 000 Old_age Always - 24716h+00m+17.450s
12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 144
171 Program_Fail_Count 0x0032 000 000 000 Old_age Always - 2
172 Erase_Fail_Count 0x0032 000 000 000 Old_age Always - 1
174 Unexpect_Power_Loss_Ct 0x0030 000 000 000 Old_age Offline - 68
177 Wear_Range_Delta 0x0000 000 000 --- Old_age Offline - 0
181 Program_Fail_Count 0x0032 000 000 000 Old_age Always - 2
182 Erase_Fail_Count 0x0032 000 000 000 Old_age Always - 1
187 Reported_Uncorrect 0x0032 100 100 000 Old_age Always - 0
194 Temperature_Celsius 0x0022 030 030 000 Old_age Always - 30 (Min/Max 30/30)
195 ECC_Uncorr_Error_Count 0x001c 116 100 000 Old_age Offline - 0/135697424
196 Reallocated_Event_Count 0x0033 100 100 003 Pre-fail Always - 0
231 SSD_Life_Left 0x0013 096 096 010 Pre-fail Always - 1
233 SandForce_Internal 0x0000 000 000 000 Old_age Offline - 16640
234 SandForce_Internal 0x0032 000 000 000 Old_age Always - 21632
241 Lifetime_Writes_GiB 0x0032 000 000 000 Old_age Always - 21632
242 Lifetime_Reads_GiB 0x0032 000 000 000 Old_age Always - 17728
SMART Error Log not supported
SMART Self-test Log not supported
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.