Mzsmunna
10/16/2019 - 1:38 PM

cmd CN1


--- System Configuration Dialog ---

Continue with configuration dialog? [yes/no]: n


Press RETURN to get started!



Router>en
Router#con
% Ambiguous command: "con"
Router#conf
Configuring from terminal, memory, or network [terminal]? 
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#int f0/1
Router(config-if)#ip add
% Incomplete command.
Router(config-if)#ip address
% Incomplete command.
Router(config-if)#ip address 192.168.1.1 ?
  A.B.C.D  IP subnet mask
Router(config-if)#ip address 192.168.1.1 255.255.255.0
Router(config-if)#no shutdown

Router(config-if)#
%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up

Router(config-if)#int f0/0
Router(config-if)#ip address 192.168.2.1 255.255.255.0
Router(config-if)#no stutdown
                       ^
% Invalid input detected at '^' marker.
	
Router(config-if)#router
                  ^
% Invalid input detected at '^' marker.
	
Router(config-if)#exit
Router(config)#hos
Router(config)#hostname RO
RO(config)#int f0/0
RO(config-if)#ip address 192.168.2.1 255.255.255.0
RO(config-if)#no shutdown

RO(config-if)#
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up

RO(config-if)#exit
RO(config)#do wr
Building configuration...
[OK]
RO(config)#
RO#
%SYS-5-CONFIG_I: Configured from console by console