kylemanna
11/13/2014 - 9:55 PM

cleanflight.troll.txt

10:03 < toobluesc> where can I find the schematic for the massive acro controller?
10:03 < toobluesc> or afro rev5 I guess
10:03 < ReadError> you dont
10:04 < Tobad> http://www.abusemark.com/downloads/naze32_rev3.pdf
10:04 < Tobad> naze manual
10:04 < toobluesc> Tobad: that doesn't have a schematic
10:05 < varesa> what do you need rev5 for?
10:05 < toobluesc> I'm trying to determine if there is a hardware inverter for the frsky telemetry port
10:05 < toobluesc> the user manuals are damn near useless
10:06 < Tobad> https://www.massiverc.com/PrestaShop/en/index.php?controller=attachment&id_attachment=29
10:06 < Tobad> massive manual
10:06 < toobluesc> yeah, no use
10:06 < toobluesc> doesn't even mention telemetry other then the controller cli commands
10:06 < varesa> toobluesc: I'm not 100% sure, but I'd say it has
10:07 < toobluesc> varesa: I've seen things hinting htat it does
10:07 < toobluesc> wanted to confirm as it's not working
10:07 < toobluesc> I figured if I enabled the telemetry feature on cleanflight, wired it up, and then add acclx/y/z on my x9d I'd see the accelerometer data
10:08 < varesa> did you arm the copter?
10:08 < toobluesc> no, not yet
10:08 < varesa> Again, I'm not 100% sure on cleanflight, but I think you need to arm it
10:09 < varesa> as the telemetry port is shared with the usb
10:09 < ReadError> it does..
10:09 < varesa> it uses the arm status as a toggle between usb/configurator and frsky telemetry
10:09 < ReadError> look at the fricken part by the frsky port
10:11 < toobluesc> ReadError: You must me king troll? and have the end all small part decoder guide?
10:11 < toobluesc> s/me/be
10:12 < toobluesc> varesa: I have usb unplugged to avoid any issues with that
10:12 < varesa> toobluesc: still need to arm
10:12 < toobluesc> not sure if I'm arming it, I don't have the motors wired up
10:12 < toobluesc> I'll give it a try later
10:13 < toobluesc> the CSC is just all sticks down and in to corners like a naza?
10:14 < Tobad> throttle only
10:14 -!- BlackJohnny [~black@188.24.154.47] has quit [Read error: Connection reset by peer]
10:15 < toobluesc> ahh, now I'm getting accel data
10:15 < toobluesc> thanks Tobad and varesa -- arming it worked
10:15 < Tobad> good
10:15 < toobluesc> sweet
10:17 < ReadError> toobluesc, unfortunate you couldnt figure out your clone hardware...
10:19  * toobluesc rolls eyes and smacks the shit out of ReadError
10:21 < ReadError> bitch you wouldnt touch me
10:21 < Tobad> just ignore him toobluesc..  =)
10:23 < ReadError> such logic, needs schematic, cant identify part less than a cm away from pin